Cylindrical grease separator model MEL

These separators have a circular bottom. They are manufactured by simultaneous projection moulding of polyester with fibreglass (PRFV) and are very economical.

Their dimensions are reduced and normally their installation is made under the floor supported on a flat concrete bed correctly levelled.
(Installation Instructions).

Dimensions

Depending on the number of meals served by the biological filter, the capacity of the filter is established. BUPOLSA has a range of capacities standardized by the manufacturing process according to the following dimensions:

Cilindric Grease Separator
Capacity (litres) Meals Ø (mm) Height (mm)
1.000 500 1.120 1.370
2.000 1.000 1.610 1.320
3.000 1.400 1.610 1.890

* Illustrative table. To consult more capacities-dimensions, please contact our technical service.

Operation

The grease separator is based on the difference in specific weights between water and grease. The water enters the intermediate part of the tank with a loss of velocity of the effluent, which first allows a separation of solids and, in turn, a separation of greases and detergents, which are captured on the surface of the separator. The effluent is collected at the intermediate part, thus avoiding the possibility of the fats being evacuated.

Maintenance

  • Regular maintenance will be carried out. Thus, the separator will be inspected, emptied and cleaned.
  • The frequency of maintenance will be performed according to the grease storage capacity of the tank.
  • After each emptying, the separator must be filled with clean wateragain.

PDF Sheet

 Product Sheet PDF